Valence-variable Catalysts for Redox-controlled Switchable Ring-opening Polymerization

As a representative class of sustainable polymer materials, biodegradable polymers have attracted increasing interest in recent years. Despite significant advance of related polymerization techniques, realizing high sequence-control and easy-handling in ring-opening (co)polymerizations still remains a central challenge. To this end, a promising solution is the development of valence-variable metal-based catalysts for redox-induced switchable polymerization of cyclic esters, cyclic ethers, epoxides, and CO₂. Through a valence-determined electron effect, the switch between different catalytically active states as well as dormant state contributes to convenient formation of polymer products with desired microstructures and various practical performances. This redox-controlled switchable strategy for controlled synthesis of polymers is overviewed in this Review with a focus on potential applications and challenges for further studies.     

Identification and quality evaluation of different processed products of Aconitum carmichaelii by ultra-high-performance liquid chromatography-quadrupole time-of-flight tandem mass spectrometry and ultra-high-performance liquid chromatography-tandem mass spectrometry

Aconitum carmichaelii is widely used to treat chronic and intractable diseases due to its remarkable curative effect, but it is also a highly toxic herb with severe cardiac and neurotoxicity. It has been combined with honey for thousands of years to reduce toxicity and enhance efficacy, but there has been no study on the chemical constituent changes in the honey-processing so far. In this study, the chemical constituents of A. carmichaelii before and after honey-processing were characterized by ultra-high-performance liquid chromatography-quadrupole time-of-flight tandem mass spectrometry. The results showed that a total of 118 compounds were identified, of which six compounds disappeared and five compounds were newly produced after honey-processing, and the cleavage pathway of main components was elucidated. At the same time, 25 compounds were found to have significant effects on different products, among which four compounds with the biggest difference were selected for quantitative analysis by ultra-high-performance liquid chromatography-tandem mass spectrometry. This study not only explained the chemical differences between the different products, but also helped to control the quality of the honey-processed products more effectively, and laid a foundation for further elucidating the mechanism of chemical constituent change during the honey-processing of A. carmichaelii.     

High capacity and cycling stability of poly(diaminoanthraquinone) as an organic cathode for rechargeable lithium batteries

Poly(1,5‐diaminoanthraquinone) is synthesized by oxidative polymerization of diaminoanthraquinone monomers and investigated as an organic host for Li‐storage reaction. Benefiting from its high density of redox‐active, Li⁺‐associable benzoquinone groups attached to conducting polyaniline backbones, this polymer undergoes its cathodic reaction predominately through Li⁺‐insertion/extraction processes, delivering a very high reversible capacity of 285 mAh g^?1. In addition, the PDAQ polymer cathode exhibits an excellent rate capability (125 mAh g^?1 at 800 mA g^?1) and a considerable cyclability with a capacity retention of ～160 mAh g^?1 over 200 cycles, possibly serving as a sustainable, high capacity Li⁺ host cathode for Li‐ion batteries. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 235–238     

Multipore Zeolites: Synthesis and Catalytic Applications

In the last few years, important efforts have been made to synthesize so‐called “multipore” zeolites, which contain channels of different dimensions within the same crystalline structure. This is a very attractive subject, since the presence of pores of different sizes would favor the preferential diffusion of reactants and products through those different channel systems, allowing unique catalytic activities for specific chemical processes. In this Review we describe the most attractive achievements in the rational synthesis of multipore zeolites, containing small to extra‐large pores, and the improvements reported for relevant chemical processes when these multipore zeolites have been used as catalysts.     

Integrated One‐Flow Synthesis of Heterocyclic Thioquinazolinones through Serial Microreactions with Two Organolithium Intermediates

The synthesis of pharmaceutical compounds via short‐lived intermediates in a microreactor is attractive, because of the fast flow and high throughput. Additionally, intermediates can be utilized sequentially to efficiently build up a library in a short time. Here we present an integrated microfluidic synthesis of biologically active thioquinazolinone libraries. Generation of o‐lithiophenyl isothiocyanate and subsequent reaction with aryl isocyanate is optimized by controlling the residence time in the microreactor to 16 ms at room temperature. Various S‐benzylic thioquinazolinone derivatives are synthesized within 10 s in high yields (75–98 %) at room temperature. These three‐step reactions involve two organolithium intermediates, an isothiocyanate‐functionalized aryllithium intermediate, and a subsequent lithium thiolate intermediate. We also demonstrate the gram‐scale synthesis of a multifunctionalized thioquinazolinone in the microfluidic device with a high yield (91 %) and productivity (1.25 g in 5 min).     

载体表面酸碱性质对无碱水溶液中Au催化的甘油氧化反应产物选择性的调控作用

甘油(GL)是一种重要的生物平台分子,通过催化选择氧化反应将其转化为具有高附加值化学品是可持续发展化学化工的重要课题之一.以Au为催化剂的GL水相选择氧化反应可以生成甘油酸(GLA)、二羟基丙酮(DHA)、羟基丙二酸(TTA)、羟基乙酸(GCA)和乳酸(LA)等多种产物.通常,该反应需要碱(NaOH)存在时才能进行,产物往往以GLA为主(选择性40%-70%),副产物主要有GCA, TTA和草酸(OA).一般认为,可溶性碱(OH-)是通过夺取GL分子中羟基上的质子而诱发反应的.尽管在Au催化的反应体系中从未检测到有甘油醛(GLD)生成, GLD和/或DHA被认为是该反应的中间物种.本课题组前期工作表明,氧化物(TiO2, Al2O3, ZrO2, CuO等)负载的纳米Au催化剂能够在无碱(无外加OH-)水溶液中选择性催化GL氧化生成DHA(而不是GLA).因此, OH-的存在与否很可能会改变水溶液中Au催化剂上GL氧化反应的途径.本文试图回答当GL的水溶液中不存在NaOH时, Au催化剂载体的表面酸碱性质是否也会对GL氧化反应的选择性产生调控作用.我们选用Mg/Al比(x)不同的MgO-Al2O3样品为Au催化剂的载体,以尿素为沉淀剂,采用沉积沉淀法制备了相应的Au/MgO-Al2O3(x)催化剂样品.采用X射线衍射、电感耦合等离子体-原子发射光谱仪、透射电镜以及N2吸附-脱附等温线等对MgO-Al2O3(x)和/或Au/MgO-Al2O3样品的物相、元素组成、Au颗粒大小以及比表面积等进行了表征分析;采用NH3和CO2程序升温脱附(TPD)分别对MgO-Al2O3(x)载体表面的酸、碱性进行了测定. NH3-TPD和CO2-TPD结果表明,随着Mg/Al比x从0增加至4.8, MgO-Al2O3(x)的表面酸量从0.94降到0.20μmol/m2,而其表面碱量却从0.05剧增至0.80μmol/m2.因此,载体中MgO含量越多或Mg/Al比越大,其酸性越弱而碱性越强.在无碱水溶液中的催化反应结果表明, Au/MgO-Al2O3(x)上GL氧化反应的主要产物为DHA, GLA以及GCA等.随着x值(催化剂表面碱性)不断增大,产物DHA的选择性从约80%下降到10%左右,而GLA的选择性却从约4%增加至约50%.当载体为酸性最强的Al2O3(x =0)时,产物DHA的选择性为最高(80%).由此可见,载体表面的酸碱性质决定了无碱水溶液中Au催化剂上的GL氧化产物的分布. 此外,当保持Au粒子的尺寸基本不变(如3.1或6.6 nm左右),而改变载体的酸碱性质时, Au/MgO-Al2O3催化GL氧化反应的活性(TOF)可相差8-9倍.本文还通过改变Au/MgO-Al2O3样品焙烧温度,制备了表面酸碱性质相同而颗粒大小不同的三个Au/MgO-Al2O3(0.2)催化剂,考察了Au粒径对GL氧化反应选择性的影响.在这三个催化剂上, Au颗粒的平均尺寸分别为2.8,3.2和6.6 nm, GL氧化反应的产物选择性近乎相同(DHA和GLA的选择性分别为65%和15%左右),但平均尺寸为6.6 nm Au粒子的催化活性(TOF)是3.2 nm Au粒子的1.6倍,2.8 nm Au粒子的2.7倍.因此,本文建立了载体表面酸碱性质与无碱水溶液中GL氧化产物选择性之间的关系,通过改变载体表面酸碱性质实现了对无碱水溶液中Au催化剂上GL氧化反应选择性的调控.尽管载体酸碱性质和Au粒子尺寸都对Au/MgO-Al2O3催化剂的本征活性有重要影响,但载体酸碱性质的影响更显著.     

Regulating Molecular Recognition with C‐Shaped Strips Attained by Chirality‐Assisted Synthesis

Chirality‐assisted synthesis (CAS) is a general approach to control the shapes of large molecular strips. CAS is based on enantiomerically pure building blocks that are designed to strictly couple in a single geometric orientation. Fully shape‐persistent structures can thus be created, even in the form of linear chains. With CAS, selective recognition between large host and guest molecules can reliably be designed de novo. To demonstrate this concept, three C‐shaped strips that can embrace a pillar[5]arene macrocycle were synthesized. The pillar[5]arene bound to the strips was a better host for electron‐deficient guests than the free macrocycle. Experimental and computational evidence is provided for these unique cooperative interactions to illustrate how CAS could open the door towards the precise positioning of functional groups for regulated supramolecular recognition and catalysis.     

Morphology‐Controlled Synthesis of Organometal Halide Perovskite Inverse Opals

The booming development of organometal halide perovskites in recent years has prompted the exploration of morphology‐control strategies to improve their performance in photovoltaic, photonic, and optoelectronic applications. However, the preparation of organometal halide perovskites with high hierarchical architecture is still highly challenging and a general morphology‐control method for various organometal halide perovskites has not been achieved. A mild and scalable method to prepare organometal halide perovskites in inverse opal morphology is presented that uses a polystyrene‐based artificial opal as hard template. Our method is flexible and compatible with different halides and organic ammonium compositions. Thus, the perovskite inverse opal maintains the advantage of straightforward structure and band gap engineering. Furthermore, optoelectronic investigations reveal that morphology exerted influence on the conducting nature of organometal halide perovskites.     

Ultraviolet C radiation influences the robustness of RNA integrity measurement

The analytical and clinical validity of analyses of RNA samples destined for clinical diagnosis and therapeutic management is directly impacted by RNA quality. RNA is affected by heat, enzymatic degradation, and Ultraviolet (UV) light. RNA from three eukaryotic cell lines was degraded by heat, RNase, or UV light. RNA integrity values obtained with the benchmark Agilent Bioanalyzer 2100 system were compared with those from the more recent QIAxcel Advanced system. The application of this novel method has allowed us to unravel differences between RNA biophysical and biochemical degradation modes. Agilent RNA integrity number (RIN) and QIAxcel RIS were comparable in heat‐degraded and RNase III‐degraded RNA. Agilent RIN and QIAxcel RIS were comparable at a RIN decision level of 7 in UV‐degraded RNA but not overall. The QIAxcel RIS method was more precise than Agilent RIN for RIN<8, while the inverse was true for RIN≥8. Greater degradation of mRNA and rRNA in UV‐damaged samples hampered the Agilent RIN calculation algorithm. Overall, RIS was more robust than RIN for assessing RNA integrity. The ΔΔCt‐values for heat‐ and UV‐degraded RNA samples showed slightly higher correlation with RIS than with RIN. RNA integrity can be used to categorize RNA samples for suitability for downstream gene expression analyses, independently of the RNA degradation mechanism. The new method QIAxcel is more robust and therefore allows more accurate categorization of compromised RNA samples.     

Sonochemical Synthesis of Gold Nanoparticles by Using High Intensity Focused Ultrasound

The sonochemical synthesis of gold nanoparticles (GNPs) with different shapes and size distributions by using high‐intensity focused ultrasound (HIFU) operating at 463 kHz is reported. GNP formation proceeds through the reduction of Au³⁺ to Au⁰ by radicals generated by acoustic cavitation. TEM images reveal that GNPs show irregular shapes at 30 W, are primarily icosahedral at 50 W and form a significant amount of nanorods at 70 W. The size of GNPs decreases with increasing acoustic power with a narrower size distribution. Sonochemiluminescence images help in the understanding of the effect of HIFU in controlling the size and shapes of GNPs. The number of radicals that form and the mechanical forces that are generated control the shape and size of the GNPs. UV/Vis spectra and TEM images are used to propose a possible mechanism for the observed effects. The results presented demonstrate, for the first time, that the HIFU system can be used to synthesise size‐ and shape‐controlled metal nanoparticles.